Dan,
Where did you get the copper tubing you used to fit the Big Pinions from?
I burned out the bearing on my 380 just recently, but I'm trying to restore it(marinade). I think the 14T caused it. So I've been wanting to install 20T-26T pinions on this motor, but couldn't find a tube strong enough to shove onto the shaft.
My 8 cell pack is in the works. Once I purchase a Race 20....I may try 9 or 10 cells. <---This will have to be recorded on video because I'll only do this a couple times, just to showoff at my LHS.
One guy at my LHS has his Speed 400 on a 26T, but he doesn't have the proper pack for this application.
-Ryan
__________________
M18-blown motor and stripped servo.
MRS4- running once again.
Wishlist: Losi Mini T, Kyosho Mini Z, the AktionRC 540 conversion set, and a few packs from Blindbatts.
|